Want to learn to program microcontrollers?
In modern electronics even while implementing any major systems require some kind of device that would have had their memory and this memory we could write a sequence of commands for execution by the numerous moves. Say if the input 1 and 2 is the value, at the inlet 22 and 21 appears 220V, so to speak and triggered by the starter. It is primitive, but actually and operates the microcontroller. Microcontrollers have so many, like brands on the market, so for the successful implementation of their ideas, you just need to have knowledge on programming these systems, everything else you can buy on the electronic market. Knowing the basics of assembler you will be able to program a variety of devices. In what direction to move We first need to study some literature on the topic "microcontroller Programming for beginners", and then be taken to the practical tasks. Fear not, if you powered up the controller correctly, burn it all, it is usually smart development with protection and short circuit protection in load from power surges and generally from a lot of counter and correct connections.
I came across a website in the Internet mastercpu.EN
I do not know to believe him or not, I bought them of course, but judging by the advertisement on the website, for all those wishing to represent as much as 108 lessons, time is 55 hours.
I guess the author has created a guide to action for those who and not strong programming and electronics is seen only in books. But with all this, looking for solutions to their ideas.
As I wrote earlier, to ensure that this manual is read, you need basic knowledge to have, at least to be able to solder and create with their hands. If you know how to solder and in your Arsenal there are quite a few sorts of electronic toys, such kind of designer will help you to move to a qualitatively new level of development. of
the Main thing is that the emphasis is rather than on the schematic, here everything is clear, if basic knowledge is available. The emphasis is on the system management controller. Most importantly, you will learn programming, you will understand how and what is happening in this mysterious case on which is written "Microcontroller", look at the block diagram how and at what level written program (firmware) for this device. Write a simple solution, something like if one were to close, then there must now be interrupted or something in this direction. You can use the logic of the controller and the programming language. There are controllers and even has its own language and its display, but it is expensive solutions, our will be easier. I try to write in native code, complex devices are not required.
There is a set of commands, which, when loaded for execution are processed in real time with reference to any process or event. To describe everything and everyone need to debug and programmer electronics, which would have been on you and with electronics and programming. Additionally you here in the course will discuss how to develop a charge for the device. What are the communications protocols between devices 1-WIRE, RS232, I2C, SPI . Yes and things that other can not privy to the intricacies of programming the controller to count for swearing. Well for example (Manchester code).
All the protocols that I wrote, they are all known and in this course (as written in the description) will be pursued at different levels. To write applets, and protocols need to know and coding for this and created this lesson, if not like, then I am not guilty, I do not recommend it, but just tell you that I found on the topic and what purpose will it be used for self-education
<<<< Back >>>>