Electric oven in the sauna! Pros and cons of such decision.
Decided to build a home sauna. The barn is! Electricity is! Near the forestry! What else do you need In General, we decided to say to go to the study and collection of material about building saunas, so no smoke and fumes, so environmental fuel! In General, then decided to put in a sauna conventional electric oven! About how to put it and what problems arise, I will try to tell you!
will probably Start with the basics. Sauna this the same room, only pairs not too wet! In order to maintain the necessary climate in the sauna room should string up and need automation to use and have at least a special stove. I think the technology is not as complicated as it is described on the Internet. As they say the eyes are looking, and make up. You should start with the premise that everything should be natural and what chemistry. The second phase involves the oven, it is almost the most important attribute of a sauna.
When rushed to see the stove for the sauna, it was found that all of them already and all have electric automation coming from the factory. It turns out that to maintain the temperature in the sauna can say so without much difficulty. Automation neither of which is large, it all works out for the firmware. What is fear Stove for saunas this is the same electrical device like a TV or VCR! The stove is sold in packing, consists of several elements, all just need to properly collect and all so to speak to do according to the instructions. What I found in the package "Electric heater for sauna"
Big iron box with shelves under stones, there is a place where there are large heating elements. Tny connected and displayed on the block. There are certainly complicated the oven, and simple. I bought the option of "All inclusive", there is a parageneratorom, with plunger pump. There is a subtlety when buying a stove, it varies by capacity. Approximately 1 kilowatt power of the heater is 1 cube meter of the area of the sauna. The saunas of some manufacturers is the remote control. There are sensors and temperature and humidity, but they also go in the oven. You need to choose such that has the optional all the necessary amenities that you need. All in the oven has its terminals and everything is connected according to the scheme. There is even a description of the installation and wishes even on the level of installation of the furnace relative to the floor of the sauna.
as for me As an electrical and principled in the sauna is not as complicated as we would like to see! It is not difficult to connect the wire as shown in the figure. Introductory main power cable you need to connect on the remote control. There are power terminals. If you are included in the set and the steam generator, it also needs to connect to clemam. I think you will not mix up the power cable wires management. It is important to understand that if you mix up something, then "Bang" you guaranteed! Do not forget the voltage of the sauna oven, a large part is powered from the mains 380V. There are also these that are included in the circuit of single-phase power, but not much. If all the heaters that are powered by phases to include in a single phase circuit, the current in the wires will be total, he really will grow up. So, what about the fact must be remembered when buying the stove and start when the supply cable.
<<<< Back >>>>