The specificity of the connection of the furnace in the sauna
Saunas are different, the stove, too, are different! In any case if you follow some General rules, it is possible to connect an electric fire safe is not that hard.
the wiring diagram of difficult moments does not have any electrician that you want can handle it. The essence is that all controlled by the controller (a special unit with the firmware and processor, something like a computer), he in turn is tied to a control panel that is displayed on the outer panel of the stove. Probably all spacecraft in the designer "LEGO", pack cubes at the pictures and you will have happiness!
I think it is not difficult to collect, difficult to satisfy all of the requirements and comply with all conditions of installation. It is not difficult to understand that where humidity and voltage, these facilities are considered "high-risk areas". In the Sauna should not be bare wires, and places where people could touch the electrical contacts. High humidity and high temperatures do not reduce the risk of electric shock. Not at all. On the contrary, people in such conditions even more vulnerable to electricity. If you are properly collected, it is worth remembering that the humidity and temperature over time destroy the insulation of the supply cables. If you know about it, we need at least very good to think things through. The wires should be divorced and isolated and should not touch the hot housing themselves and to each other does not take place in earnest.
I think no one uses the controls in the sauna. The control panel is usually made in the dressing room, there is a constant room temperature and its constant humidity. You should start with powering and the shield to install a vending machine with constant current, given the values of the furnace. The main thing that the system would be turned off if a short circuit in the load. Tena is often burned, but most often they punch to the body. Knowing such a feature of these products, you need the stove to be well grounded. Which machine to choose Preferably with a leakage current less than 30mA!
back To the power cable also has a number of important requirements with regard to the cable that goes from the remote to the stove, then load the minimum and special requirements for posting there. The main thing that was mine for a common ground.
the Cable is usually hidden in the wall, there are options when conduits are laid. Box practical, but over time they turn yellow and their temperature twists and warps as a result, the appearance deteriorates.
the steam Generator and the stove to the 220V is not usually connected with vinyl cable, such a cable in the sauna is not recommended. Mainly used special cable insulation which withstands temperatures for a long time and will not crack or burst. In my case, a piece of cable came with the microwave from the factory, I have left it with only one hand to put on the block, but with other side of the machine the supply voltage. In the kit there is a piece of metal sleeves, the part of the cable that goes from the oven and goes somewhere in a public place must be Packed in a metal sleeve. If no sleeves, then bend by bending a piece of pipe and run the cable in the pipe! Safety first.
Actually, all I wrote above is idial! In actual fact it is much sometimes easier is. The main thing is to ensure that in any case you are unable wet body to touch the stove. Just wall it with a wooden fence, it is like a warning for the line not to go! Such care may help you get rid of any difficulties in the installation of cable, you can say to them is, the main thing to look periodically and make the stove revision. If you see that the insulation was broken and needs to be changed! If bummed ten or emboss machine sometimes, it is worth reflecting on what all this and clear the fault before you hurt someone.
<<<< Back >>>>