What make the frame for a high-voltage fly swatter
I was doing different frames of wood, most practical out. Since I work in the winder motors, I have sticks for pynovka grooves of the shaft, so I decided to basically of them to build their design. I didn`t do a lot of them, even thought it was not like this. When did it first and hung it on the porch, then gathered a Council of neighbors, which have been vividly discussed me. Then I did her bedroom and the kitchen perimeter and flies markedly diminished. Came as something to visit the neighbors asked for the kickback to make it too, something like that. I have not had good diodes and I used 226, not strange, but pulled 6-tier multiplication paired with conder at 400V. In General, I did the perimeter then it is not of wood, and used a plastic case from some crap. As it turned out not bad, but attached to the plastic wire of the perimeter came as a complete gemorra, it slides. I foolishly smeared with PVA glue and ... After such modification the charge on power fell, there was a leakage current and a certain to see small breakdown on glue. Another time I used the adhesive polymer, it seems dry, but also proved detrimental to the design. Best of all showed common threads. Wound and tied with threads, the main thing to wind on the dielectric. Everything else as your heart dictates. My options have you seen, now on order three things make the photo here. These frames are also made of wood, but I decided to open them now with paint, perhaps this system will be better for the breakdown, because I think to put an 8-fold multiplication. Here is and all advice about how to do the perimeter for high-voltage fly swatter. How will make it be so, it is important that she was not conducting current, and everything else is a trifle.
How to do frame for the perimeter from high-voltage flycatchers
<<<< Back >>>>