Unusual way of connecting led strip
As you understand, the options to connect a simple led strip great many, the main thing to have desire and to show imagination. Consider this case, when the space for mounting the power supply at the location of the backlight or led strip just yet. This can be useful if you want to highlight say the ceiling or the bottom of the car. And in that case and in another the PSU need somewhere to hide or make otherwise lost or aesthetic perception of all his plans, or to perform technically the idea is practically impossible. Well, where you for example will hide the PSU if you put it underneath the car There and damp, and there external factors, Yes anything can put your power supply fails, if you screw it to the bottom of your car. What to do The decision is unusual, the power supply, put in the cabin, and the tapes themselves are mounted on the bottom in plastic tubes in order to avoid any external influences.
There is options when the led strip is very long and everything else she has and RGB, in which case it can be connected to three power supplies, all three of the power supply unit can include from one point on the primary circuit.
that entrepreneurs Have the question often arises as to illuminate the window a large window if the perimeter cannot be inserted one led strip (its just the length is not enough*), in that case take a standard tape five meters and abutting consistently with the same tape as the result the output is not standard led tape 10 long meters. Hope her power and current consumption and put in parameters such as need for power supply. To connect the two tapes can be very simple, for this purpose, bilateral connectors, which are placed within a few minutes.
Now I will tell you how to connect RGB led strip, so it is not shining white, or in what sequence, and was so to speak a manageable segment of the backlight.
the Essence of the solution is very simple. Take RGB tape, as well as the PSU is properly selected according to the power and controller. The controller allows you to control the brightness and light output of the tape, can be combined. Or more green, or blue, or red. So to say your choice!
Connects RGB tape so, first connect the power adapter to the network, because to him, the controller, then connect the led strip. Tape RGB has 4 outputs. Each individual output is what is controlled with relation to common wire color.
Usually at the RGB on the ribbon, and the controller outputs labeled as "B" - blue; R - red; G - green; "V+" is a common power wire. All you can do is to accurately connect the ends if you mess up, then nothing will happen.
Like the power supply, and the controller is calculated according to the load under each type of tape your controller. Tape RGB also differ in power consumption. Need to pay attention, this is important.
Sometimes the case when you need in series or in parallel to connect two RGB led strip type how to connect
Everything is done just like regular tape, as all calculated current consumption relative to the power supply, plus the controller. that is all, no hard or anything, everything is simple and clear. Good luck, now all rushed to connect itself such that tape lighting, they consume less current and less space in the apartment is!
<<<< Back >>>>