Connection Options led strips!
As there are many different type of LEDs, and there is a different range of led strips. They differ not only because they Shine in different colors, but that will consume different proportions. Given all of the above, you should choose a PSU very carefully!
the power supplies are different, if desired, and if hands not curves, power supply for led strip, you can collect and most. No problems or anything. A couple of transistors, a transformer and a Zener diode, here is everything you need, plus a couple of resistors. But it is to say the option for "Kulibin", we the people are civilized and will work in a slightly different way. All going to connect to use the brand.
There is a power supply with a drawstring under 220 In there without it. If lace is not, then you need to find out exactly where terminals under AC220V Input, and connect a piece of wire with a plug. In most cases the connection is not difficult, all signed, all labeled. If you buy a Chinese version, it will be cheaper, but the markings on the block. And then you have to look at the schema itself and pathways, identify the primary circuit of the transformer when the transformer circuit), in General, a vegetable garden... it is Better to buy a branded product and not to bother my head about his connections. In any case, always look at the manual, it is supposed to come with any type of power supplies. Very often in the instructions to the power supply is to connect it to the tape.
Led strip connects to the wire clips. Usually it is so important with this connection the exact match tracks with the contact plates and the fortress of contact clamp. If you have PVCs howling own power supply and no clip-ons, you can tape and solder. Important paths do not overheat or they will fall behind and will not aesthetically pleasing and durable.
I will now draw two basic ways to connect.
In the first case, use the connector. To connect wires, take the connector platoon of the clamping lever. Then put the connector on the end of the led strip and release the lever clamping mechanism. Check the strength of the connection and you are done! We have a tape with wires, we plug it to the connector of the PSU is if we have a direct connection.
that you can use and soldering in the connecting practice, I have already described above. So what if no connectors, then take a soldering iron 30W, so as not to overheat the tape and soldered contacts as required by the technical specifications. I just want to add here that. Contacts soldering is much better than the connectors and clips, this should be considered when working. If you tape will be used to illuminate the underside of the car, then you definitely will need to solder, because the machine vibrates and eventually the connector will simply weaken, and diode tape will stop glowing.
When connecting to a single power supply multiple tapes you need to know something. Two ribbons sequentially meshing is not necessary, the tape will burn in two two times dimmer due to the larger voltage drop. If you want two ribbons to be powered from one power supply and it will power can withstand, the best tape to hang in parallel to the output of the power supply.
<<<< Back >>>>